CNC Router Johor, CNC Router Perak

- Phenolic Pressure Foot Donut is top-down mounted for mounting on Infinite Cast Pressure Feet.

- For Integrated Wand System.
- For AXYZ CNC Router only

- 5Y Pressure Foot - Intergrated Wand System.

- Single Head Machines require the left hand option.

More Details...

- For AXYZ CNC Router only 

- For AXYZ CNC Router only

- For AXYZ CNC Router
- 5HP ELTE Spindle 3.3kw (5HP) Maximum Speed: 24000 PRM 380V Type: TMPE4 10/2 Includes Spindle Cable. Collet Type: ER32 Part Number

- For AXYZ CNC Router only

- For Becker pumps with grease zerks, use only white lithium grease.
- For AXYZ CNC Router

Pressure mat safety systems are installed onto the floor around your AXYZ CNC Router. These are used to guard the operator/persons by stopping anyone entering the cutting zone. The pressure mat operates when pressure is applied to the mat surface. This result is the machine will stop (pause) until the zone is clear and the job will need to be re-started by the operator.

More Details...

- The Unist Plastic Nozzle Tip is a replacement spray tips for misting systems. Old and broken spray tips can be easily removed from misting wands and replaced using this part.

- The ELTE PF Reducer Bushing is used specifically for 5 hp ELTE spindles. It enables the use of the bellows or nose rider options for the smaller spindles.

- This is a replacement blast gate for high capacity pressure feet.

- The Blast Gate allows you to adjust the amount of air going into the pressure foot depending on the application.

More Details...

- The newly constructed Universal Pressure Foot Donut is now blind (top-down) mounted. Our new blind mount donut replaces the old bottom-up design and fits all AXYZ High Capacity and 5Y pressure feet.

More Details...

- The bellows system provides an extremely efficient vacuum performance. The bellows completely enclose the tooling, virtually elimination all vacuum leakage.

The Pneumatic Air Cylinder 1'' Stroke is a replacement for the ones on the pressure feet (PFL-E-S-Z and PFR-E-S-Z). These must be replaced if the pressure foot has suffered a collision and the pistons are bent.

More Details...

- For AXYZ CNC Router Machine

These are replaceable brush rings which clip into place on the swarf cones used on various manual and quick release (ATC) spindles on the original Pacer CNC Routers only. Used correctly, they will eliminate the scattering of swarf and dust by the cutter and they enhance the performance of the cyclonic extraction system to maintain a clean and tidy workplace

HK bearings are the most commonly used bearings on CNC routers.  Star and THK bearings look quite similar so carefully check the drawings below to ensure you have selected the correct bearings.  Also check the axis and match the bearings using the pictures.

More Details...

- The Holding Break is used to hold either a stepper or servo Z axis in place when the power is turned off.